Whirlpool 66161279 Use and Care Guide download pdf (Page 15)

Timer

To set a 1 to 24-hour delay until the air conditioner turns off

(the air conditioner must be On):

1. Press TIMER. The display will show remaining hours before

the air conditioner will turn off.

2. Press the up or down arrow button to change the delay time

from 1 to 24 hours.

3. Press TIMER again while the time remaining is shown on the

display or wait 5 seconds for the unit to automatically save

the settings.

NOTE: When the air conditioner turns off, the red LED on the

Power button lights for Standby mode. The Timer LED turns off.

4. To view the time remaining before the air conditioner turns off,

press TIMER once. Pressing Timer again while the time

remaining is shown on the display will cancel the setting.

Set the air conditioner to turn on, keeping the previous

settings:

1. Turn off the air conditioner.

2. Press TIMER. The display will show remaining hours before

the air conditioner will turn on.

3. Press the up or down arrow button to change the delay time

from 1 to 24 hours.

4. Press TIMER again while the time remaining is shown on the

display, or wait 5 seconds for the unit to automatically save

the settings. The display will show the current room

temperature. The Timer LED will remain on.

5. To view the time remaining before the air conditioner turns on,

press TIMER once. Pressing Timer again while the time

remaining is shown on the display will cancel the setting.

Set the air conditioner to turn on, changing the previous

settings:

1. Adjust the mode to Cool, Eco (on some models), Overnight

(on some models) or Fan Only.

2. Press the up or down arrow button to set the temperature

between 61ºF and 86ºF (16ºC and 30ºC).

3. Adjust the fan speed to Low, Medium, High or Auto.

NOTES:

■ Auto fan speed and Temperature cannot be selected in

Fan Only mode.

■ In Eco (on some models) and Cool modes, Auto fan

speed is selected automatically.

4. Turn off the air conditioner.

5. Press TIMER. The display will show the remaining hours

before the air conditioner will turn on.

6. Press the up or down arrow button to change the delay time

from 1 to 24 hours.

7. Press TIMER again while the time remaining is shown on the

display, or wait 5 seconds for the unit to automatically save

the settings. The Timer LED will remain on.

8. To view the time remaining before the air conditioner turns on,

press TIMER once. Pressing Timer again while the time

remaining is shown on the display will cancel the setting.

Cancel Timer:

Press TIMER twice to cancel the Timer.

Using the Remote Control

NOTE: Remote control may differ in appearance.

NOTE: One CR2025 battery (included) powers the remote

control. Replace battery after 6 months of use, or when the blue

light flashes 5 times every 10 minutes.

To remove the battery, place the remote control face down. Using

your thumbnail, press and hold the tab to release the battery

door, and pull out battery door with your index finger.

To reinstall the battery, place the battery into the battery door as

shown in the following illustration, matching the positive (+) side

of the battery with the positive (+) side of the battery door. Slide

the battery door into the remote control.

Timer

Mode

Power

Fan Speed

A. Tab

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Comments to this Manuals

No comments

Whirlpool 66161279 Use and Care Guide Page 15

Comments to this Manuals

Related products and manuals for Split-system air conditioners Whirlpool 66161279