Whirlpool 66161279 Use and Care Guide download pdf (Page 5)

Electrical Requirements—All Models

The electrical ratings for your air conditioner are listed on the

model and serial number label. The model and serial number

label is located on the right-hand side of the air conditioner

cabinet.

Specific electrical requirements are listed in the “Power Supply

Cord Electrical Requirements” chart. Follow the requirements for

the type of plug shown in the chart.

Recommended Grounding Method

This air conditioner must be grounded. This air conditioner is

equipped with a power supply cord having a grounded 3 prong

plug. To minimize possible shock hazard, the cord must be

plugged into a mating, grounded 3 prong outlet, grounded in

accordance with all local codes and ordinances. If a mating outlet

is not available, it is the customer's responsibility to have a

properly grounded 3 prong outlet installed by a qualified electrical

installer.

It is the customer's responsibility:

■ To contact a qualified electrical installer.

■ To assure that the electrical installation is adequate and in

conformance with National Electrical Code, ANSI/NFPA

70-latest edition, and all local codes and ordinances.

Copies of the standards listed may be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169

Power Supply Cord

NOTE: Your air conditioner’s device may differ from the one

shown.

This window air conditioner is equipped with a power supply cord

required by UL. This power supply cord contains state-of-the-art

electronics that sense leakage current. If the cord is crushed, the

electronics detect leakage current and power will be

disconnected in a fraction of a second.

To test your power supply cord:

1. Plug power supply cord into a grounded 3 prong outlet.

Power

Supply

Cord Electrical Requirements

■ 115-volt (103.5 min. - 126.5 max.)

■ 0-12 amps

■ 15-amp time-delay fuse or circuit breaker

■ If there is a “Single Circuit Only” label on the

unit, use on a dedicated single-outlet circuit

only.

■ If a dedicated single-outlet circuit is not

available, then it is the customer’s

responsibility to have a single-outlet circuit

installed by a qualified electrician.

■ If there is no “Single Circuit Only” label on the

unit, the unit may be used on any branch

circuit of correct voltage and adequate current

protection rating.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

A. Test button

B. Reset button

POWER

TEST

RESET

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comments to this Manuals

No comments

Whirlpool 66161279 Use and Care Guide Page 5

Comments to this Manuals

Related products and manuals for Split-system air conditioners Whirlpool 66161279