Whirlpool 66161279 Use and Care Guide download pdf (Page 17)

3. Remove the filter from the grille by lifting to release the

slotted tabs on the top and bottom of the grille.

4. Use a vacuum cleaner to clean air filter. If the air filter is very

dirty, wash it in warm water with a mild detergent.

NOTE: Do not wash the air filter in the dishwasher or use any

chemical cleaners. Air dry the air filter completely before

replacing to ensure maximum efficiency.

5. Reattach the air filter to the air intake grille.

6. Insert the air intake grille into the slots on the air conditioner

and snap into place.

Cleaning the Front Panel

1. Turn off the air conditioner.

2. Clean the front panel with a soft, damp cloth.

3. Air dry the front panel completely.

Repairing Paint Damage

Check once or twice a year for paint damage. This is very

important, especially in areas near oceans or where rust is a

problem. If needed, touch up with a good grade enamel paint.

Annual Maintenance

Your air conditioner needs annual maintenance to help ensure

steady, top performance throughout the year. Call your local

authorized dealer to schedule an annual checkup. The expense

of an annual inspection is your responsibility.

TROUBLESHOOTING

Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.

Air conditioner will not operate

■ The power supply cord is unplugged. Plug into a grounded

3 prong outlet. See “Electrical Requirements.”

■ The power supply cord has tripped (Reset button has

popped out). Press and release RESET (listen for click; Reset

button will latch and on some devices, a green light will turn

on) to resume operation.

■ A household fuse has blown, or circuit breaker has

tripped. Replace the fuse or reset the circuit breaker. If the

problem continues, call an electrician. See “Electrical

Requirements.”

■ The Power button has not been pressed. Press POWER.

■ The local power has failed. Wait for power to be restored.

Air conditioner blows fuses or trips circuit breakers

■ Too many appliances are being used on the same circuit.

Unplug or relocate appliances that share the same circuit.

■

Time-delay fuse or circuit breaker of the wrong capacity is

being used.

Replace with a time-delay fuse or circuit breaker

of the correct capacity. See “Electrical Requirements.”

■ An extension cord is being used. Do not use an extension

cord with this or any other appliance.

■ You are trying to restart the air conditioner too soon after

turning off the air conditioner. Wait at least 3 minutes after

turning off the air conditioner before trying to restart the air

conditioner.

Air conditioner power supply cord trips (Reset button

pops out)

■ Disturbances in your electrical current can trip (Reset

button will pop out) the power supply cord. Press and

release RESET (listen for click; Reset button will latch and on

some devices, a green light will turn on) to resume operation.

■ Electrical overloading, overheating, cord pinching or

aging can trip (Reset button will pop out) the power

supply cord. After correcting the problem, press and release

RESET (listen for click; Reset button will latch and on some

devices, a green light will turn on) to resume operation.

NOTE: A damaged power supply cord must be replaced with a

new power supply cord obtained from the product manufacturer

and must not be repaired.

A. Slotted tab

B. Lift slotted tab to remove.

C. Air intake grille

D. Air filter

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Comments to this Manuals

No comments

Whirlpool 66161279 Use and Care Guide Page 17

Comments to this Manuals

Related products and manuals for Split-system air conditioners Whirlpool 66161279